Accelerator Cable; Disassembly; Assembly - Stiga PARK 120 2016 Workshop Manual

Edition Workshop Manual
2016 PARK 120 - PARK 220
6.5

Accelerator cable

6.5.1

Disassembly

A
6.5.2

Assembly

1. Pour some oil drops on the two cable terminals and move the wire a few times inside its
sheath.
2. Route the cable through the same previous cable path.
3. Mount the new fixing clamps in the exact point of the previous ones.
4. Adjusting the cable
B
6.5.3
Chapter
6 Control cables
1. Remove the engine casing
2. Release the cable (A) from the engine.
3. Pull the cable unit through the centre of the
machine, passing it under the seat.
4. Disassemble the accelerator control (B).
5. Pull the accelerator control back and the cable
until it comes out from under the plastic cover.
6. Detach the cable unit from the accelerator
control.
Page
49
2.1.1