Stiga PARK 120 2016 Workshop Manual page 42

Edition Workshop Manual
2016 PARK 120 - PARK 220
14
5
12
13
4. Replace the bottom belt casing (12), two
screws.
5. Centrally install the belt (C) for the operating
equipment clutch on the double pulley (3).
C
6. Replace the upper belt casing (19), two screws.
19
7. Install and tighten the central top bolt (14) and
the tensioning arm on the belt (C). Please note
that the tensioning pulley must be positioned
(2x)
on the inside of the belt.
8. Install the spring (13). The spring is connected
to the tensioning arm from the bottom end,
once inserted, turn the opposite end clockwise
by half a turn and connect it to the frame. See
the figure.
9. Replace the engine casing
(2x)
Chapter
5 Belts
2.1.1
Page
42