Description; Disassembly - Stiga PARK 120 2016 Workshop Manual

Edition Workshop Manual
2016 PARK 120 - PARK 220
3.1

Description

The chain gear is connected directly to the steering wheel by means of a steering shaft.
A chain with cables is connected to the gearwheel and consequently to the rear frame. In
this condition the rear frame is forced to steer in relation to the front frame when the driver
uses the steering wheel.
3.1.1

Disassembly

Before commencing disassembly operations, make a note of the route taken by the cable/
chain system so that the new components can be installed in the exact same way.
E
1. Remove one end (A or B) of the cable from the rear part of the frame.
2. Slacken bolt (C) which holds the rear pulleys in place. Slacken the bolt so as to be able
to remove the cable from both the top and bottom pulleys.
3. Remove the front pulleys (D) by removing the circlips (E).
4. Slacken the second cable from the frame and completely remove the cable/chain system.
A
D
E
C
Chapter
3 Steering wheel
B
Page
24