Table of Contents
Advertisement
B.2.2
VA Detection for mixed traffic
In general the sensor should be installed such that it is pointing at 45degrees towards
oncoming bicycle traffic. The sensor is to be configured with 'Use Motion' setting enable,
sampling rate set to 4Hz and the sensitivity set to level 4.
•
Sample Rate – 4Hz
•
Detection Distance - 8 Ft
•
Auto baseline Sensitivity – 4
•
Use Motion – Set
•
Latch Car Subchannel – Set
For a 1.8m lane the detection distance should be set to 8ft.
.
Figure 75 : VA and Count setup for shared traffic
Note: Multiple bikes that cross the virtual detection zone simultaneously will be counted as
a single bike.
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Page 111 of 117
Status
Date
Doc. No.
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Issued
March 2020
667/HB/47200/000
Advertisement
Table of Contents
