Table of Contents
Advertisement
5. International Mode: The access point should be set to international mode. This setting
ensure that the 'recalibration timeouts' drop down list will only have the appropriate
values required for HA approval. This setting is managed by selecting the Access Point
within TrafficDot, which displays the Access Point Config Window. Within this
window, click AP Config and open the Detection tab. At the bottom of the tab select
'International Mode'.
6. Set Access Point Colour Code: Selecting the Access Point within TrafficDot opens the
Access Point Config Window. Within this window, click AP Config and open the
Advanced tab. The junction colour code should then be copied from the configuration
spreadsheet into the AP Colour Code field.
7. Siemens protocol must be switched on within the access point to ensure correct
communications with the standard interface card. Open the System Config - Other
tab in the Access point Config Window and click Custom Application Settings,
then check the STS Enable box to switch Siemens protocol on.
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Figure 39 : Recalibrate Timeout Setting
Page 53 of 117
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
Status
Issued
Date
March 2020
Doc. No.
667/HB/47200/000
BH17 7ER
Advertisement
Table of Contents
