Commissioning; Access Point Commissioning; Standard Interface Card/Wimag Loop Detector Replacement Card Commissioning; Figure 65 : Traffic Dot 2 Map Mode - Siemens 667/HB/47200/000 Manual

Wimag vehicle detection system general handbook

Table of Contents

15 Commissioning

This section is used to outline the commissioning methodology for the WiMag Vehicle

Detection system.

The first step will be to confirm that the access point is operating as expected. The

following steps should be performed on each access point;

1. Connect to the access point using the 'Traffic Dot 2.0' application

2. Enable the map mode.

3. Each detector should have been positioned on the map in its relative position.

4. Confirm each detector 'indication' is a reflection of the sensor's true status.

15.2 Standard interface Card/WiMag Loop Detector Replacement Card

Commissioning

The access points connect to one or more interface card. The following step should

ensure the interface card is receiving the detector information from the appropriate access

point;

1. Connect to the interface card

2. Select the 'Board Test' page on the web interface

Version

Last Editor

Jeerh, Manpreet

Document

WIMAG GENERAL HANDBOOK

Name

Page 84 of 117

Siemens Mobility Limited

Sopers Lane, Poole, Dorset

Status

Issued

Date

March 2020

Doc. No.

667/HB/47200/000

BH17 7ER

Table of Contents