Table of Contents
Advertisement
Bracket
10.1.1 Mounting the Access Point
Part Number
667/CI/47230/000
Table 10 : Signal Head Mounting Kit Document Reference
Due to cabling requirements, it is recommended that access points are mounted on traffic
signal poles. A specially designed L-bracket allows the access point to be fixed to the top
of a traffic signal head.
The following steps provide for the mounting of the access point above a signal head;
1. Remove the rear bolt from the signal head mounting bracket.
2. Replace with the M10 bolt provided.
3. Fit the access point L bracket using the M10 washer and nut provided, making use
of the front signal head mounting for anti-rotation.
4. Attach the double socket arm to the L-bracket.
5. Attach the AP to the double socket arm.
6. Orientate the AP in the direction depicted, within the junction/installation drawing,
and tighten the double socket arm to secure.
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Double
Socket Arm
Mounting
Balls
Figure 45 : Ball and Socket Mounting Detail
Document Description
Installation instructions for Signal Head Mounting Kit
Page 62 of 117
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
AP / Repeater
Status
Issued
Date
March 2020
Doc. No.
667/HB/47200/000
BH17 7ER
Advertisement
Table of Contents
