Special Function Menu - Novexx Solutions ALX 73 Series Operating Manual

P
RODUCT DESCRIPTION
Ribb. eco. limit
The ribbon economisation limit corresponds to the length of the no-print zone on the
label at the point where ribbon autoeconomisation will be activated.

more than about 10 mm in length.
Setting range: [2.0...100.0] mm; presetting: 10.0 mm
Print contrast
The setting for print contrast, i.e. the degree of blackening in the printout.
CAUTION!
The
the higher the setting of the
This applies especially to settings over 100%. Therefore note the following recom-
mendation:

Setting range: [1...110%]; presetting: 60%

SPECIAL FUNCTION menu

Delete Job
Deletes the active print job.
When the online key is pressed, the printer interrupts processing of the active print job.
Delete Spooler
Deletes the print job wait queue (spooler).
When the online key is pressed, all print jobs in the print spooler are deleted.
Store Parameters
Save settings in the parameter menu.
Parameter settings are saved in a text file on memory card (directory FORMATS\).
Also takes into consideration parameters belonging to uninstalled options.
Settings: ["Without adj. par", "With adj. par"]
41 | Printer parameter menu
•
"Thermal/head lift": Thermal direct printing with automatic head lifting over
unprinted areas (protects the printhead)
•
"Thermal printing". Thermal direct printing (ribbon end sensor shut off)
•
"Enabled": Thermal transfer printing with ribbon saving
•
"Off": Thermal transfer printing without ribbon saving
Do not activate ribbon autoeconomisation for unprinted areas unless they are
Print contrast
parameter directly affects the service life of the printhead. In general,
Always select the lowest setting that will still produce acceptable printing results.
Delete Job
Clearing ... . .
Delete Spooler
Clearing ... . .
•
"Without adj. par": Parameters containing device-specific settings are not saved.
Application: Transfer of settings to other devices (device-specific settings such as
heat resistance or sensor settings should not be overwritten).
Pre-set filename: SETUP.FOR
Print contrast, the shorter the service life of the printhead.
Operating manual ALX 73x | file version 01 | 03/2012
ALX
73x