Cut Function, Cutter - Novexx Solutions AP 5.4 Service Manual

02/10 Rev. 5.05-00

Cut function, cutter

Problem
No cutter function
Material is only par-
tially cut or not cut at
all
Cut next to re-
cognised gap
Cut offset to impres-
sion
Material moves abo-
ve or under cutter
Cutter cuts twice
[Tab. 10] Problems possibly caused by a cutter (if mounted).
SERVICE MANUAL
AP 5.4 – AP 5.6
Possible cause
Connector loose
Cutter function not activa-
ted
Photoelectric switch defec-
tive
Stepper motor or output
stage board defective
Setting of cutter position
Cutter blunt or dirty
Material problem
Gap detection
Cutter position incorrect
Unwinding too sluggish, roll
weighs too much
Double cut programmed
Solution
Plug in connector firmly.
Select and activate "Cutter" setting for parame-
SYSTEM PARAMETER > Peripheral device
ter
Check and if necessary replace switch
Check and if necessary replace
Check photoelectric switch or position of oscil-
lator disc and if necessary correct
Check and if necessary clean or replace
Only use approved materials
Check setting for parameter
PRINT PARAMETER > Cut position
correct the setting
Check and if necessary set
Check and if necessary correct
Check setting of cut function (Parameter
Print Parameter > Double Cut)
Fault Location
and if necessary
6