Print Parameters Menu - Novexx Solutions ALX 73 Series Operating Manual

P
RODUCT DESCRIPTION

PRINT PARAMETERS menu

Print speed
Print speed
The print speed (material feed) can be adapted to the combination of ribbon and ma-
terial in use to optimise the contrast intensity and the degree of blackening of the print
image.
Setting range: [2...16] inch/s; presetting: 8 inch/s
Feed speed
Feed speed
The feed speed can be increased in areas with no print. This reduces the overall print
time, especially for long labels with very little printed surface.

a different feed speed is preferred, it must be set again.
Setting range: [2...12] inch/s; presetting: 8 inch/s
Material type
Definition of the label material in use.
Settings: [endless, punched]

Material length
Label length, measured from the front (beginning) of a label to the front of the next la-
bel.
Setting range: [5...max. length
Material width
Width of the label belt (including backing paper in the case of self-adhesive material).
Setting range: [Min. width
Print direction
[33] Alignment of the print image "Foot first" (A) or "Head first" (B).
1)
2)
3)
39 | Printer parameter menu
When the print speed is changed, the feed speed is set equal to the print speed. If
•
Endless: The label material has no punches or reflex markings. The start of the
label is calculated by the set label length
•
Punched: The individual labels in the label material that is used have punches or
reflex markings that can be detected by the label sensor.
Only the "Punched" setting can be used for the ALX 73x.
2
...Max. width
A
"Max length": depends on the printhead width and memory configuration.
"Min. width": depends on the type of printer
"Max. width": depends on the printhead width and memory configuration of the printer
(PRINT PARAMETERS > Material
1
] mm; presetting: 100 mm
3
] mm; presetting: 100 mm
Printer
Printout
Operating manual ALX 73x | file version 01 | 03/2012
ALX
73x
length).
B