Cut Function, Cutter; Plug-In Card - Novexx Solutions 64 Series Service Manual

12/08 Rev. 5.01-02
Problem
No cutter function
Material is only par-
tially cut or not at all
Cut next to recog-
nised gap
Cut offset to impres-
sion
Material moves
above or under cutter
Cutter cuts twice
[9] Possible problems caused by a cutter (if applied).
Problem
Plug-in cards are not
recognised
[10] Possible faults caused by plug-in cards.
SERVICE MANUAL

Cut function, cutter

Possible cause
Plug connector loose
Cutter function not
activated
Sensor defective
Stepper motor or output
stage board defective
Setting of cutter position
Cutter blunt or dirty
Material problem
Gap detection
Cutter position incorrect
Unwinding too sluggish, roll
weighs too much
Double cut programmed

Plug-in card

Possible cause
Contacts dirty
Card not initialised
Card defective
Card type does not corre-
spond to approved type
64-xx
Solution
Check and if necessary plug in firmly
SYSTEM PARAMETER > Periph. device
Set
Check and if necessary replace switch
Check and if necessary replace
Check photoelectric switch or position of os-
cillator disc and if necessary correct
Check and if necessary clean or replace.
Don´t cut self-adhesive endless material.
Only use approved materials
Check setting for parameter
PRINT PARAMETER > Cut position
correct
Check and if necessary set
Check and if necessary set
Check setting of double cut function
PRINT PARAMETER > Double cut
(
Solution
Check and if necessary replace
Check and if necessary initialise
Check and if necessary replace
Check and if necessary replace card
Fault location
to "Cutter"
and if necessary
)
7