Jumper Switches Jp1 And Jp2 On The M30100T-Prt Board; Connecting The Pc4701 And Emulation Pod; Connecting The Cable To The Pc4701 - Renesas Emulation Pod M30100T3-RPD-E User Manual

Emulation pod for m16c/10 series mcus

Table of Contents

3.3 Jumper Switches JP1 and JP2 on the M30100T-PRT Board

The jumper switches JP1 and JP2 on the M30100T-PRT board are set to "CSP" side and "0ns" side

respectively when shipped from factory. When there is no instruction in the user's manual of your pod

probe, set these switch to the default.

Note on Setting Switches:

To connect the emulation pod to the PC4701, use the FLX120-RPD 120-pin flexible cable included

in this product package.

Figure 3.7 shows how to connect the PC4701 and FLX120-RPD. To connect the FLX120-RPD, be

sure to hold the both sides of the PC4701 side connector horizontally with the "UPSIDE" facing up.

Then secure with screws.

Figure 3.7 Connecting the PC4701 and FLX120-RPD

Note on Connecting the Cable:

Note on Securing the Screws:

• Always shut OFF power when changing the settings of the jumper switches.

• Before connecting the FLX120-RPD, always shut OFF power before connecting the

cable. The power ON state could destroy internal circuits.

• After connecting the emulator main unit to the FLX120-RPD, be sure to secure the

screws.

( 27 / 52 )

CAUTION

Table of Contents