Table of Contents
Advertisement
3.3.
Software installation procedure from the CD
CONTAINS THE LINUX 64BIT OPERATING SYSTEM
FIX :
If the APRESA base software is already installed without interface cards for whatever reason, run from
the WEB-interface: Tools->System->Install Driver. This, obviously, will install the driver for the SYNWAY
card(s).
3.3.1.
Always attach a monitor & keyboard to follow the progress of the software installation and to:
• Change BIOS settings;
• Give a confirmation to overwrite current hard drive content if the hard drive you want to use is
not empty;
• Type the pass phrase, if the hard drive is to be encrypted during installation and at each reboot;
3.3.2. BIOS setup
(Note : Controls used below refer to Phoenix BIOS, other BIOS manufacturers may be different)
Enter the BIOS configuration menu by pushing
up to 1 minute for motherboards equipped with IPMI.
Select: "GENERAL SETTINGS " :
- SET: DATE & TIME;.
Select : "BOOT SETTINGS " :
- SET : boot-sequence to:
When installing the software RAID 1 or software RAIID 5 version of APRESA
Select : "SAVE & EXIT" (enter :
3.3.3.
INSTALLATION MANUAL APRESA
THE IMAGE CD USED BY THIS INSTALLATION PROCEDURE
PROPRIETARY APRESA APPLICATION SOFTWARE
IF THE SYSTEM USES ONE OR MORE INTERFACE CARDS ALWAYS
PRIOR TO SOFTWARE INSTALLATION
Attach monitor & keyboard
DVD ,
you must set the BIOS-setting for RAID to
( RAID is handled by software )
F10
&
Y
Prepare an installation CD
COPYRIGHT © 2011-2017 VIDICODE ®
INSTALL THESE CARDS
DEL
repeatedly, directly after power on. This can take
IDE0, and if more HD-s
NO RAID
)
AND
THE
IDE1 and further. .
27
Advertisement
Table of Contents
