Software Installation; Call Recorder Apresa - Vidicode V-Tap ISDN PRI Manual

2.2

Software installation

External software is needed to extract the recorded calls from the
Tunnel data that is produced by the V-Tap ISDN. Also, when the calls are
first stored on an SD card, external software is needed to interpret this
data from the card, especially when the data is encrypted.
The Tunnel data stream, coming directly from the V-Tap, can be sent to
the

Call Recorder Apresa

NOTE:
The V-Tap needs at least one Apresa or PC upload-channel license before
the Apresa or V-Archive software can record your calls.
2.2.1
The Call Recorder Apresa
Debian operating system. The Apresa can receive Tunnel data from the
V-Tap, convert this data into audio files and store these into its own
database.
The Apresa can receive multiple data streams from many V-Tap units
simultaneously. In that case the recordings of different locations are
centrally stored in one database.
To setup the Apresa to act as a Tunnel server for a V-Tap, go to
System settings, Network tab and enable "V-Tap" as is shown below:
NOTE1: Apresa's IP address is the "Tunnel Server Address" in the V-Tap.
NOTE2: Be sure the Encryption password is the same as in the V-Tap unit.
V-Tap ISDN PRI Manual EN v1.23 Nov 2021
or the V-Archive
Call Recorder Apresa
is recorder software running on the Linux
software.
© 2018-2021 Vidicode 8