Conversion To Right-Hand Operation - Bruno ELECTRA-RIDE II Installation Manual

CONVERSION TO RIGHT-HAND INSTALLATION
The circuit breaker must be
turned OFF while changing
from left-hand to right-hand
installation.
Otherwise, the board will not
accept the change.
4-ganged DIP switch
• switch 1 = diagnostic
• switch 2 = diagnostic
• switch 3 = right-hand install
• switch 4 = coast delay
CHANGING CONTROLS FROM RIGHT TO LEFT ARMREST
SRE-1550 02-09-2009
As shipped from the factory, the Electra-
Ride II is set up for left-side installation
TM
(as viewed from the bottom of the
stairs).
To convert the elevator for right-side
installation:
1. Make sure the circuit breaker switch on
the rear of the carriage is in the OFF
position.
2. Remove the left side carriage cover
(the cover without the speed control).
3. Set the No. 3 DIP Switch on the
4-ganged dip switch to the ON
position.
LEARN switch
1. Remove the switch housing weldment
by removing the Torx head machine
screw under the arm. The trim hold-
ing the harness on the backside of the
arm slides off.
2. To disconnect the harness under the
seat, remove the seat hinge nut.
3. Slide the harness cable guide off.
4. Reinstall the seat hinge nut.
5. Remove the 2 screws from the swivel
switch cover, then remove the cover.
(continued on next page)
31
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®