Table of Contents
Advertisement
INSTALLATION
UPPER BUMPER BRACKET
CONNECTING THE BATTERY
CHARGER AND ROUTING THE
WIRING HARNESS
After routing the wire harness out of sight,
a small piece of double sided foam tape
can be applied to the harness plugs for
attachment under the rail.
Note: If the charger plug and wire are
located in a vulnerable location, use of a
plug lock is recommended to prevent acci-
dental unplugging. Plug locks are available
at hardware and department stores.
Choose one
of these (2)
mounting
holes
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
1. Install the upper bumper bracket to
rail.
2. Before tightening the bracket, check to
make sure that the bumper wires are
not trapped under the bumper bracket
at the lower landing.
3. Tighten the bracket.
1. Position the charger in a suitable
permanent location where it will not
create a tripping hazard.
2. Route the battery charger wiring
harness along the back side of the rail.
3. Secure this harness to the rail clamps
with wire ties or double-sided tape
(see note to left).
4. Secure the charger in the chosen loca-
tion (Step 1) by inserting (2) screws
(provided) through the mounting holes
in the charger base.
Choose one
of these (2)
NOTE: There are (2) mounting holes
mounting
on each side of the charger base.
holes
Choose one of the two on each side.
14
Be sure that this wiring is mounted
securely to avoid damage.
SRE-1550 02-09-2009
Hide quick links:
Advertisement
Table of Contents
