Adjustments; Speed; Seat Height - Bruno ELECTRA-RIDE II Installation Manual

SPEED ADJUSTMENT
speed adjustment
potentiometer
CW = faster
CCW = slower
Turn potentiometer
counterclockwise.
SEAT HEIGHT ADJUSTMENT-Residential and Commercial Units
SRE-1550 02-09-2009
The Speed Adjustment Potentiometer is
located on the top of the carriage.
To adjust:
1. Loosen the collet nut on the speed control
potentiometer approximately one-half turn.
2. Turn the potentiometer completely in the
counterclockwise direction.
This is the starting point.
3. Turn the Potentiometer in the clockwise direction,
aligning the slotted shaft with the weight range
of the user.
4. The speed may be adjusted by turning the
slotted shaft on the Potentiometer (clockwise
= faster, counterclockwise = slower).
5. With the customer seated on the unit,
perform several test runs to arrive at the most
to appropriate speed setting.
6. When the speed has been set satisfactorily,
retighten the collet nut.
7. Recheck the speed.
Turn clockwise, aligning
THEN
slotted shaft with weight
range of customer
1. Remove footrest assembly, then gently pull
the extra wire from the hole in the pivot
bolt.
2. Remove the bolt in the outer mounting
tube.
3. Adjust the seat height, replace thebolt and
secure.
4. Reinsert the extra wire in the pivot bolt.
5. Replace the footrest assembly.
33
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®

ADJUSTMENTS