Table of Contents
Advertisement
ASSEMBLY
Residential and Commercial Units
bumper bracket
This rail must be
installed 1/2" to 1"
above stair nosing.
Otherwise, footrest will
hit the steps, causing
intermittent operation.
SRE-1550 02-09-2009
1. Determine whether a left- or right-side
installation is appropriate for the site. "Left"
or "right" refers to the side of the stairway on
which the rail is installed (as viewed from the
bottom of the stairs).
Unless otherwise specified Bruno Stairway
Elevators are shipped from the factory in the
left-side configuration.
Conversion to right-side installation is easy
(instructions included later in this manual).
2. Identify and locate lower rail section appropriate
to the installation (left or right).
LOWER BUMPER BRACKET INSTALLATION
1. Assemble the bumper bracket to the lower
rail.
FITTING THE RAIL
1. Determine the correct length for the rail by
measuring along a straight line placed on
the stairs. (SEE STEP 2 IN THE APPLICATION
GUIDE, next page) To that amount, add
Measurement B (STEP 4 IN THE APPLICATION
GUIDE). This process will allow you to custom
fit the elevator to your customer by determining
the most comfortable seat-to-floor height within
the space available at the top of the stairs.
NOTE: The rail must rest approximately 1/2"
to 1" above nosing of the steps and
extend from the lower floor to a point
beyond the nosing of the top step (see
Application Guide Step 4).
In some cases where the bottom
landing is made of material such as
concrete, ceramic tile or slate, the last
bracket on the landing may be omitted
with a bracket added on the second step
from the bottom and top of stairway.
7
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
INSTALLATION
Hide quick links:
Advertisement
Table of Contents
