Yearly Maintenance Operations; Belt Replacement Note - Bruno ELECTRA-RIDE II Installation Manual

MAINTENANCE

YEARLY MAINTENANCE OPERATIONS

BELT REPLACEMENT NOTE

©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
• Clean rails, racks and wheels. Regrease.
• Check for dry and/or worn belts. Lubricate.
• Check rail wear. There should be no groove.
• Clean charging contacts (both carriage and rail ends)
withScotch Brite®.
• Check battery voltage (load test).
• Check safety switches (footrest, carriage, seat).
• Check armrest switch and keyswitch (if applicable).
• Check battery charger output:
• Load test using remote controls:
▫ Check voltage while carriage is
traveling up.
▫ Test with carriage against contacts.
▫ Test with carriage away from contacts.
▫ Check contacts and lights.
• Check speed.
• Check seat belt for wear and proper operation.
• Examine exposed wiring. Are there any cuts or abrasions?
• Verify operation of seat swivel mechanism. Does it move
easily and lock in place correctly?
• Check that all hardware is properly tightened.
After replacing the belt, tighten the new belt to the proper
tension. Tighten the motor bolts to the torque specified on
drawing SRE-00648 at the back of this manual.
34
SRE-1550 02-09-2009