1. Manuals
  2. Brands
  3. Bruno Manuals
  4. Stairlifts
  5. OUTDOOR ELITE CRE-2110E
  6. Operator's manual

Bruno OUTDOOR ELITE CRE-2110E Operator's Manual

Curve custom curved rail stairlift
Hide thumbs Also See for OUTDOOR ELITE CRE-2110E:

Advertisement

Table of Contents

CRE-2110E
OUTDOOR
ELITE CURVE
CUSTOM CURVED RAIL STAIRLIFT
Operator's Manual
Retail Customers
Please contact your Bruno dealer with any questions or service concerns,
using the contact information shown below:
(Dealer: Place contact information below.)
Dealer Name:
Address:
Telephone No.:
REV. 04-02-2018
1

Advertisement

Table of Contents
loading

Related Manuals for Bruno OUTDOOR ELITE CRE-2110E

Summary of Contents for Bruno OUTDOOR ELITE CRE-2110E

  • Page 1 CRE-2110E OUTDOOR ELITE CURVE CUSTOM CURVED RAIL STAIRLIFT Operator’s Manual Retail Customers Please contact your Bruno dealer with any questions or service concerns, using the contact information shown below: (Dealer: Place contact information below.) Dealer Name: Address: Telephone No.: REV. 04-02-2018...
  • Page 2 Bruno dealer. Bruno reserves the right to use information indicated on this form in its online, video, audio and printed materials. Names will be abbreviated to ensure the privacy and anonymity of the individual. Best wishes from the Bruno Team.

  • Page 3: Table Of Contents

    Warranty ....... . 22-23 Declarations of Conformity ....24-25 ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018...
  • Page 4 Power Supply: 24VDC battery charger powered by 120V outlet This custom curved rail stairlift has been tested to perform within the operating temperature range of 0˚F (-18˚C) to 125˚F (52˚C). ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 5 ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...

  • Page 6: Safety

    NOTE: After a harsh winter, especially when the stairlift has not been used for an extended period of time, have the stairlift inspected by an authorized Bruno dealer before putting the stairlift back into service. ©B Bruno Independent Living Aids, Inc.
  • Page 7 Only in the event of a prolonged power outage (more than one hour) will it be necessary to turn the power off (circuit breaker switch on the carriage) and unplug the charger from the wall outlet to conserve battery charge. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 8 DO NOT REMOVE! DO NOT REMOVE! ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...

  • Page 9: Circuit Breaker

    Reset it, if circuit breaker necessary. Possible causes of circuit breaker tripping: • foreign object jamming the rail or gear rack; • exceeding the rated weight capacity of the stairway elevator. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...

  • Page 10: Seating

    The seat also flips up to facilitate storage. NOTE: If you cannot remain seated upright, please lean towards the upstairs side for the smoothest ride. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...

  • Page 11: Operation

    9. Turn the armrest key switch to ON. 10. Press and hold the rocker switch (located on the front edge of one of the armrests) to travel UP / DOWN the rail. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 12 19. If the top seat cover will not be used, fold and store in the bag attached to the underside of carriage covers the seat (see left). DO NOT REMOVE! NOTE: Never remove the bottom carriage covers, except for service. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 13 4. Press again and hold until the unit arrives at the top or bottom of the rail. NOTE: The seat will again stop and beep once to indicate end of travel. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...

  • Page 14: Diagnostic Codes

    Off Charge and Not Parked Parked and Charger Not Detected Battery Voltage Critical Battery Voltage Low Seat Safety Switch Open Up Limit Switch Open Down Limit Switch Open Mid-Rail Park Active Soft Stop Switch ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...

  • Page 15: Charging

    Using the transmitter, call it back to the other end of the stairs when needed. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 16 If it has to be exposed BLINKS BLINKS battery defective or heavily to water, do not use ALTERNATELY ALTERNATELY sulfated until inspected. FAST BLINK partially open circuit; bad contact or battery sulfation battery connector reversed ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 17 3. Twist the fuseholder cap and pull out to charger power switch remove the fuse. 4. Replace with the same size and type fuse: (Bussmann GMD-2A or equivalent) 2A, Slo-Blow, 5 x 20mm. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 18 • Keep the battery charger plugged into a live outlet at all warranty. times. • At least once a year, have the elevator examined, cleaned and lubricated by a qualified, authorized Bruno service rear of transmitter technician. TRANSMITTER BATTERY REPLACEMENT •...
  • Page 19 TROUBLESHOOTING Your CRE-2110E is not operating correctly. What should you do? Before calling your Bruno dealer, refer to the solutions listed below. This could save you an un- necessary service call! • Key switch. Is the rocker switch inoperative? Make sure the key is in the ON position.

  • Page 20: Battery Charger

    • Visual check. Do you notice anything about your elevator that is different or out of place? If your CRE-2110E continues to function improperly or not at all after completing the preceding checklist, contact an authorized Bruno dealer to perform all required service, repair and maintenance operations. ©B Bruno Independent Living Aids, Inc.

  • Page 21: Vacation And Long-Term Storage

    To recharge, simply turn on the circuit breaker, reconnect the charger to the wall outlet and wait until the charger LED’s indicate that the batteries are fully recharged. ©B Bruno Independent Living Aids, Inc. CRE-2110E Operator 04-02-2018 ®...
  • Page 22 ◊ All MAJOR COMPONENTS are free of defects in material and workmanship for a period of fi ve years after the date of installation. ◊ All labor to address any product defect by a Bruno Authorized Dealer is covered for the fi rst 30 days after installation.
  • Page 23 ◊ All labor to address any product defect by a Bruno Authorized Dealer is covered for the fi rst 30 days after installation. WHAT IS NOT WARRANTY COVERAGE: ◊ Damage to units caused by misuse, abuse, accidents, neglect or modifi cations NOT made by a Bruno Authorized Dealer.
  • Page 28 Valet Signature Seating Vertical Platform Lift ® Curved-Rail Stairlifts Vehicle Lift Solutions Bruno Independent Living Aids, Inc ® 1780 Executive Drive, Oconomowoc, WI 53066 www.bruno.com ©Bruno Independent Living Aids, Inc. ® All illustrations and specifications in this document are based on the latest product information available at the time of publication.

Table of Contents