Positioning Foot Clamp Assemblies - Bruno ELECTRA-RIDE II Installation Manual

INSTALLATION
POSITIONING FOOT CLAMP ASSEMBLIES-Residential and Commercial Units
• Install foot clamps at least 1-1/2"
(38 mm) from wall.
• Provide additional clearance if
seat needs to swivel against wall.
• Before securing all clamps, run
carriage assembly up and down
stairway to check seat clearance
over the entire travel length.
Foot Clamp Placement
• bottom landing
• first tread up from bottom landing
• top landing
• first tread down from top landing
• closest tread above and below rail
joint(s)
• minimum of every third tread over the
remainder of the staircase.
NOTE: If top or bottom clamp is omitted
because the landing is cement
or ceramic tile, or if the owner
wishes not to drill holes in the
landing, a set of clamps should
be added on the second-to- last
step and at the top of stairway.
rail
1/2" to 1"
(13-25 mm)
above nosing
If threaded fastener
extends below a stair
tread that is exposed,
it can be trimmed flush
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
rail mounting foot
clamp assembly
with pliers.
1. Install rail mounting foot clamps in
the placement pattern shown to the
left.
Leave a minimum space of 1-1/2"
(38 mm) from the wall.
2. For ease of installation, finger tighten
all clamps to rail.
Position the clamp assembly so the
nut is closest to the wall.
3. Slide top and bottom clamps down
until firmly seated on step. When
installing on carpeted stairs, tap the
clamps with a rubber mallet to
compress carpet and cushion before
anchoring to steps.
4. Securely install one screw near the
wall on the top and bottom of foot of
clamp assemblies. This will enable the
installer to change the position of the
rail if necessary and prevent drilling
excess holes.
12
SRE-1550 02-09-2009