Seat Swivel And Seat Arm Adjustment - Bruno ELECTRA-RIDE II Installation Manual

INSTALLATION
SEAT SWIVEL AND ARM ROTATION-Residential and Commercial Units
push up latch
to swivel seat
ARM ADJUSTMENT-Residential and Commercial Units
arm lock release
PSM-10002 screws
arm adjustment screws
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
arm lock release
1. Fold the seat up when the Elevator is
not in use.
2. To unfold the seat when ready to use
the Elevator, simply push down the
seat, or the arm rest.
The swivel latch located directly under
the seat allows the seat to rotate in
45-degree increments.
3. To disengage the latch, lift up on
either the right or left lever found at
the front edge of the seat.
4. Release the lever to lock the seat in
place.
5. Push the arm lock lever to rotate the
arm up to 90 degrees for easy transfer.
The arm then can be rotated back to
its original position.
The arm locks in place automatically
when the latch re-engages.
If you are not adjusting the arm, skip to
Step No. 4.
1. To adjust to a wider setting, loosen
the arm adjustment screws on the
bottom of the seat (see left).
2. Rotate the arm out to the desired
position.
3. Tighten the arm adjustment screws.
4. Screw (2) PSM-10002 into the seat
bottom to lock the armrest in place.
If extending the arms to maximum
width, be sure to adjust the rail-to-
wall distance to compensate for the
increased angle of rotation.
18
SRE-1550 02-09-2009