Advertisement
Table of Contents
- 1 Table of Contents
- 2 Regulatory Information and Specifications
- 3 Safety
- 4 Parts of the SRE-2010
- 5 Circuit Breaker
- 6 Seating
- 7 Operation
- 8 Diagnostic Codes
- 9 Charging
- 10 Maintenance/Transmitter Battery Replacement
- 11 Battery Charger
- 12 Troubleshooting
- 13 Vacation and Long-Term Storage
- 14 Warranty
- Download this manual
Advertisement
Table of Contents
Related Manuals for Bruno ELECTRA-RIDE SRE-2010
Summary of Contents for Bruno ELECTRA-RIDE SRE-2010
- Page 1 SRE-2010 ELECTRA-RIDE™ ELITE STAIRWAY ELEVATOR Operator’s Manual Technical Service email: service@bruno.com www.bruno.com 1780 EXECUTIVE DR., P.O. BOX 84, OCONOMOWOC, WI 53066 USA TELEPHONE:(262) 567-4990 FAX: (262) 953-5501 1-800-882-8183 REV. 03-20-2008...
- Page 2 Bruno dealer. Bruno reserves the right to use information indicated on this form in its online, video, audio and printed materials. Names will be abbreviated to ensure the privacy and anonymity of the individual. Best wishes from the Bruno Team.
-
Page 3: Table Of Contents
Safety ........5-6 Parts of the SRE-2010 ......7 Circuit Breaker . -
Page 4: Regulatory Information And Specifications
(armrest and two remotes) Maximum Incline: 45 degrees Seat Swivel: 0, 60 and 90 degrees at the top; 45 degrees at the bottom Power Supply: 24VDC battery charger powered by 120V outlet ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008... -
Page 5: Safety
• Make sure the seat is locked in the correct riding position. • Be certain the seat swivel is locked in place before attempting to get on or off the stairway elevator. ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008... - Page 6 Your SRE-2010 is battery powered and will continue to operate for some time during a power outage. The length of operation will depend on the battery condition, the length of the stairs and the weight of the rider.
-
Page 7: Parts Of The Sre-2010
SRE-2010 ELECTRA-RIDE™ ELITE armrest UP / DOWN rocker switch swivel release folding seat in riding position folding footrest with obstruction sensors ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008... -
Page 8: Circuit Breaker
CIRCUIT BREAKER The SRE-2010 includes an ON/OFF switch with a built-in circuit breaker located on the back side of the carriage. The circuit breaker protects the battery, controller and motor circuits in the stairway elevator carriage. It is unlikely that this circuit breaker will trip during normal use. -
Page 9: Seating
SEATING The seat assembly on the SRE-2010 is designed to swivel 90 degrees (with standard armrests) to the left and to the right, and to lock in one of the following positions: 0, 60, and 90 degrees at the top, and 45 degrees at the bottom. -
Page 10: Operation
A safety switch prevents operation of the elevator to operating speed. SRE-2010 unless the seat is locked in position at right angles to the rail (the “riding” position). Depressing and holding the 6. - Page 11 10. Release the seat swivel lever and allow the seat to lock in this position. 11. Unbuckle the positioning belt and carefully exit the seat. ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008...
- Page 12 3. Press again and hold until the unit arrives at the top or bottom of the rail. NOTE: The seat will again stop and beep once to indicate end of travel. ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008...
-
Page 13: Diagnostic Codes
Parked and Charger Not Detected Battery Voltage Critical Battery Voltage Low Seat Safety Switch Open Up Limit Switch Open Down Limit Switch Open Seat Fold Switch Open Mid-Rail Park Active Soft Stop Switch ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008... -
Page 14: Charging
Using the transmitter, call it back to the other end of the stairs when needed. ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008... - Page 15 SLOW BLINK SLOW BLINK batteries close to being fully charged batteries fully charged BLINK low voltage indication FAST BLINK battery defective or heavily sulfated ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008...
- Page 16 3. Twist the fuseholder cap and pull out to charger power switch remove the fuse. 4. Replace with the same size and type fuse: (Bussmann GMD-2A or equivalent) 2A, Slo-Blow, 5 x 20mm. ©2008,2007 Bruno Independent Living Aids, Inc.® SRE-2010 Operator 03-20-2008...
-
Page 17: Maintenance/Transmitter Battery Replacement
MAINTENANCE Your SRE-2010 is designed to provide many years of reliable service with minimal maintenance. For best service life: • Keep the rail channel clean and free of debris. • Always park the carriage at one end of the rail so that the batteries charge when the elevator is not in use. - Page 18 TROUBLESHOOTING Your SRE-2010 is not operating correctly. What should you do? Before calling your Bruno dealer, refer to the solutions listed below. This could save you an unnecessary service call! • Seat swivel. Is the seat locked in the riding position? •...
-
Page 19: Battery Charger
• Visual check. Do you notice anything about your elevator that is different or out of place? If your SRE-2010 continues to function improperly or not at all after completing the preceding checklist, contact an authorized Bruno dealer to perform all required service, repair and maintenance operations. -
Page 20: Vacation And Long-Term Storage
VACATION AND LONG-TERM STORAGE If the SRE-2010 will remain unused for an extended period of time, turn off the circuit breaker, then unplug the battery charger from the wall outlet. NOTE: The batteries may require recharging before normal use if the stairway elevator remained unused for an extended period of time. -
Page 21: Warranty
The exclusive remedy for a defect in a Bruno Stairlift shall be the repair or replacement, at the option of Bruno, of the defective part or component. After the first 30 days of this war- ranty, only parts and components are covered. This warranty does not cover labor and other services after the initial 30 days. - Page 22 Bruno, damage in shipment, or repairs undertaken by anyone other than Bruno factory employees or authorized distributors. The “original purchaser” of a Bruno Stairlift that is leased or rented shall be the person or entity acting as the lessee or rental provider.
- Page 24 • ©2006 Bruno Independent Living Aids, Inc. ® All illustrations and specifications in this brochure are based on the latest product information available at the time of publication. Bruno Independent Living Aids, Inc . reserves the right to make changes at any time without notice. Manual Back Cover 8/06-2.