Apply Grease To Folding Rail Assembly; Power Folding Rail Drive Adjustment - Bruno ELAN SRE-3050 Installation Manual

TROUBLESHOOTING
a
Wwe
APPLY GREASE TO FOLDING RAIL ASSEMBLY
NOTE: If folding rail experiences resistance
when closing, grease can be applied.
Apply at these locations:
- Between latches (Fig. 1)
- On backside of joint alignment |
block (Fig. 2).
A small amount applied to these
surfaces may allow the folding rail
to close more freely.
Fig. 1 Fig. 2
POWER FOLDING RAIL DRIVE ADJUSTMENT
NOTE: Due to tightness between gears
and shifting that occurs in shipping, a
clicking/crunching noise may come
from the power folding rail drive.
The following adjustment should
eliminate the noise.
1. Remove motor cover plate (plate with disable —
switch),held in place with 1/4" expandable panel
fasteners. | |
Loosen Phillips head screws holding motor to
mounting plate.
3. Loosen button head screws holding mounting
plate to primary bracket.
Place the blade of a flat-head screwdriver
between circular cut-out in mounting plate and
protrusion of motor. Push motor "uphill" (Fig. 1).
5. Tighten Phillips head screws while pushing motor.
Place the blade of a flat-head screwdriver in
either location shown by red arrows (Fig. 2).
- On top side of plate, twist screwdriver to pivot
plate away from rail.
- On side of plate, push plate "uphill".
|While pressing against plate at either location,
tighten button head screws.
Shifting motor and plate away from folding rail
gear train relieves pressure between gears. The
noise should be eliminated and the gears will
rotate more freely.
Fig. 2 NOTE: While adjusted at the factory, the
motor/plate may move out of optimal
position during shipping.
2