Loading The Tape Strip Feeder - Pitney Bowes DM225 Operating Manual

Reinstalling the Moistener
1. Line up the yellow tab with the yellow
slot.
2. Slide the moistener tank into position
on the Mailing Machine until the
release lever snaps into position.
3. Resume operation.

Loading the Tape Strip Feeder

The tape strip feeder is only fitted to the DM300 system.
To load the tape feeder:
1. Remove any tape strips already in
the feeder by pulling them straight
out.
2. Load the new tape strips print side
(white surface) UP.
Take up to a maximum of 50 strips
and push them into the feeder as far
as they'll go.
You'll feel a slight resistance before
they're all the way in.
See page 2-7 for instructions on printing tape strips.
If a tape strip jams in the feeder, see the troubleshooting instructions in
Chapter 6.
Maintenance
5-3