Pitney Bowes DM225 Operating Manual page 60

Maintenance
Maintaining the Moistener (continued)
Removing and Cleaning the Brush
1. Lift the brush holder up.
2. Slide the brush out towards the front
of the moistener tank.
3. Clean the brush in a mild soap
solution. Rinse thoroughly in plain
water.
Reinstalling the Brush
1. Position the brush as shown in the
top illustration so the brush's bottom
edge is under the mounting tabs.
2. Slide the brush back towards the rear
of the moistener tank.
3. Close the brush holder, press down
on it firmly, and reinstall the
moistener tank (see next page).
Removing and Cleaning the Moistener
Wick
1. Open the brush holder.
2. Press down on the wick assembly; lift
it up and out of the moistener (A).
3. Slide the wick out of the holder (B).
4. Clean the wick in a mild soap
solution. Rinse thoroughly in plain
water.
Reinstalling the Wick
1. Place the wick in the holder (B).
2. Reinstall the wick assembly (A).
3. Close the brush holder, press down
on it firmly, and install the moistener
tank.
5-2