Table of Contents
Advertisement
2.5 INSTALLING THE E2730A IN THE MAINFRAME
CAUTION
!
CAUTION
!
2.6 VXI COMPLIANCE D16/D32
2.7 VXI SIGNAL LIST
2-10
Damage to the tuner may result if it is installed in a
mainframe with power applied.
removed before installing or removing the tuner.
Damage to the tuner may result if power is applied while it
is improperly seated in a VXI module slot of the mainframe.
Ensure the E2730A is firmly seated and VXI mounting
screws are fully tightened before applying power.
Figure 2-4.
NOTE:
Before installing the tuner, ensure its logical address is set to
the proper setting (refer to paragraph 2.4).
The E2730A should be installed vertically in a C-size mainframe. Refer
to the equipment manual provided with the mainframe being used for
proper module installation instructions.
Specification for proper module installation procedures and details on
configuring the interrupt daisy chain on the mainframe backplane to
bypass empty slots, if required.
When installing the tuner in a vertical mainframe, slide it in the
appropriate module slot (any slot except 0) with the RF IN SMA connector
towards the top and the 3rd LO IN/OUT connector towards the bottom.
Figure 2-4 shows the E2730A properly installed in a vertical mainframe.
The E2730A Tuner supports 16-bit or 32-bit VXI data bus access.
The E2730A utilizes the standard multipin VXIbus P1 and P2 connectors.
The signals associated with these connectors are fully defined in Section B
of the VXIbus System Specification and, for convenience, are also
provided in paragraphs 2.2.1 and 2.2.2. The VXI 10 MHz reference
signal is further described in the following paragraph.
E2730A VXI RF TUNER
Ensure that power is
Refer also to the VXIbus
INSTALLATION
See
Advertisement
Table of Contents
