Table of Contents
Advertisement
Command
DSO?
DWS?
ENA
FMO?
FNO nrf
FNO?
FRA nrf
FRA?
FRB nrf
FRB?
GTA nrf
GTA?
GTC nrf
GTC?
GTP nrf
GTP?
HAD nrf
HAD?
IDM nrf
IDM?
IFO nrf
IFO?
IGB
INC nrf
INC?
3-24
Table 3-13. Compatibility Messages (Continued)
Response
DSO 0
DWS 0
FMO ****
FNO 0
FRA 0020.0000
FRB 2700.0000
GTA 4
GTC 4
GTP 4
HAD 0
IDM 0
IFO 0000.00000
INC 0000.1000
Description
Returns status of Digital Scan Output – always
returns 0
Request the current dwell state.
Restore to active a suspended sweep or step
operation.
Request FM offset percentage of selected IF
bandwidth.
Enable or disable frequency normalization.
Request status of frequency normalization
enable.
Select the start frequency for F1-F2 sweep
operation.
Request current start frequency for F1-F2 scan.
Select the stop frequency for F1-F2 sweep
operation.
Request current stop frequency F1-F2 scan.
Set AGC Gate Timer for AM and FM detection
modes
Request setting of AGC Gait Timer for AM and
FM
Set AGC Gate Timer for CW, SSB, and IFT
detection mode
Request setting of AGC Gait Timer for CW,
SSB, and IFT detection modes
Set AGC Gate Timer for AM Pulse detection
mode
Request setting of AGC Gait Timer for AM
Pulse detection mode
Set Handoff Address
Request Handoff Address
Set tuner manual idle mode.
Request idle mode status.
Set IF Offset Frequency
Request IF Offset Frequency
While stopped or suspended on a signal, ignore
the sample bin update.
Select frequency-to-frequency scan step increment.
Request current F1-F2 scan step increment.
E2730A VXI RF TUNER
OPERATION
Advertisement
Table of Contents
