Waters 2998 Operator's Manual page 35

• Waters SAT/IN™ Module
• Waters, or other, manual injector
• Waters autopurification system
• Other manufacturers' integrator or A/D interface device
To avoid electrical shock, power-off instruments being
Warning:
connected before making any electrical connections.
To meet the regulatory requirements of immunity from
Requirement:
external electrical disturbances that can affect the performance of this
instrument, do not use cables longer than 3 meters (9.8 feet) when you make
connections to the I/O connectors. In addition, ensure you connect the shield of
the cable to ground at one instrument only.
To connect the detector to other instruments, use the two analog-out/event-in
(I/O) connectors and their mating connectors on the rear panel.
2998 rear panel analog-out/event-in connectors
Connector B (outputs) Connector A (inputs)
+
1 Analog 1
−
2 Analog 1
3 Ground
+
4 Analog 2
−
5 Analog 2
+
6 Switch 1
−
7 Switch 1
8 Ground
+
9 Switch 2
−
10 Switch 2
+
1 Inject Start
−
2 Inject Start
3 Ground
+
4 Lamp Off
−
5 Lamp Off
+
6 Chart Mark
−
7 Chart Mark
8 Ground
+
9 Auto Zero
−
10 Auto Zero
Making signal connections 2-9