Battery Saver On/Battery Saver Mode Message - Electrical Load Reduction Actions - If Equipped - Jeep Wrangler Owner's Manual

Vehicle Settings
The following menu/submenu items are available in the
cluster display:
Speed Warning:
Sets the vehicle speed limit, which the driver is notified
through a visual and acoustic signaling (display of a
message and a symbol on the display).
When the speed warning is set, the icon should remain
visualized for the same duration time of the pop-up
message. If the driver exceeded the set speed, the icon
should remain for however long the vehicle is over the set
speed.
Driver may also turn the Speed Warning "OFF" should you
choose not to use this feature.
Passenger Air Bag — If Equipped:
Front passenger air bag may be enabled or disabled.
Phone Call Status
A pop-up message for an incoming call will appear on any
screen within your instrument cluster. The pop-up
message will appear on your screen until it is cleared out
of the call is ignored, answered, or the calling ends.
NOTE:
The Uconnect Settings can be programmed to turn the
pop-up off. This will not affect the audio menu or any
phone status information page 128.
Ú
Any incoming calls, active calls, and outgoing calls will
take the place of your audio information.
A caller's name will only be displayed if:
 A number is associated with the call. The phone
number will be displayed in place of the caller's name.
 The test/font of the name is not supported by the
instrument cluster. The instrument cluster will not
display anything in place of the name.
 The caller's name exceeds the maximum number of
characters. The last two to three digits that will fit will
be replaced with "...".
NOTE:
Any audio information will return to the instrument cluster
once the call has ended.
B S O /B
ATTERY AVER N ATTERY
M M — E
ODE ESSAGE LECTRICAL
R A — I
EDUCTION CTIONS F
This vehicle is equipped with an Intelligent Battery Sensor
(IBS) to perform additional monitoring of the electrical
system and status of the vehicle battery.
In cases when the IBS detects charging system failure, or
the vehicle battery conditions are deteriorating, electrical
load reduction actions will take place to extend the driving
GETTING TO KNOW YOUR INSTRUMENT PANEL
time and distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical loads.
Load reduction is only active when the engine is running.
It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due to
lack of electrical supply, or will not restart after the current
drive cycle.
When load reduction is activated, the message "Battery
Saver On" or "Battery Saver Mode" will appear in the
instrument cluster display.
These messages indicate the vehicle battery has a low
state of charge and continues to lose electrical charge at
a rate that the charging system cannot sustain.
NOTE:
 The charging system is independent from load reduc-
S
AVER
tion. The charging system performs a diagnostic on the
L
charging system continuously.
OAD
E  If the Battery Charge Warning Light is on it may indicate
QUIPPED
a problem with the charging system
The electrical loads that may be switched off (if equipped),
and vehicle functions which can be effected by load
reduction:
 Heated Seat/Vented Seats/Heated Wheel
 Rear Defroster And Heated Mirrors
79
Ú page 81.