Windows; Power Window Controls; Automatic Window Features; Reset Auto-Up - Jeep Compass 2023 Owner's Manual

56 GETTING TO KNOW YOUR VEHICLE

WINDOWS

P W C
OWER INDOW ONTROLS
The window controls on the driver's door control all the
door windows.

Power Window Controls

The passenger door windows can also be operated by
using the single window controls on each passenger door
trim panel. The window controls will operate only when the
ignition is in the ON/RUN position.
To open the window part way, push the window switch
down briefly and release it when you want the window
to stop.
NOTE:
The power window switches will remain active for up to
10 minutes after the ignition is placed in the OFF position.
Opening either front door will cancel this feature.
The timing is programmable within Uconnect Settings
page 145.
Ú
WARNING!
Never leave children unattended in a vehicle. Do not
leave the key fob in or near the vehicle or in a location
accessible to children, and do not leave the ignition of a
vehicle equipped with Keyless Enter 'n Go™ in the
ON/RUN position. Occupants, particularly unattended
children, can become entrapped by the windows while
operating the power window switches. Such
entrapment may result in serious injury or death.
A W F
UTOMATIC INDOW EATURES
Auto-Down Feature
The driver and front passenger door power window
switches have an Auto-Down feature. Push the window
switch down briefly, then release, and the window will go
down automatically.
To stop the window from going all the way down during the
Auto-Down operation, pull up or push the switch briefly.
Auto-Up Feature With Anti-Pinch Protection
Lift the window switch up briefly and release; the window
will go up automatically.
To stop the window from going all the way up during the
Auto-Up operation, push down or pull the switch briefly.
To close the window part way, lift the window switch briefly
and release it when you want the window to stop.
If the window runs into any obstacle during auto-closure, it
will reverse direction and then go back down. Remove the
obstacle and use the window switch again to close the
window.
NOTE:
Any impact due to rough road conditions may trigger the
auto-reverse function unexpectedly during auto-closure. If
this happens, pull the switch lightly and hold to close the
window manually.
WARNING!
There is no anti-pinch protection when the window is
almost closed. To avoid personal injury be sure to clear
your arms, hands, fingers and all objects from the
window path before closing.
R A -U
ESET UTO P
Should the Auto-Up feature stop working, the window
probably needs to be reset. To reset Auto-Up:
1. Pull the window switch up to close the window
completely and continue to hold the switch up for an
additional two seconds after the window is closed.
2. Push the window switch down firmly to open the
window completely and continue to hold the switch
down for an additional two seconds after the window
is fully open.