Setting Up Password / Resetting Replacement Timers - ELGA PURELAB Classic - US Operator's Manual

ELGA
Password Screen
UV Lamp Replacement Date Screens
5.5

Setting Up Password / Resetting Replacement Timers

CAUTION!
Step 1 - Enter Consumable Replacement Timer Set-up
1. SWITCH OFF at power inlet module.
2. PRESS and HOLD left hand button and SWITCH unit
back on. The unit will now enter the Consumable Timer
set up display.
3. RELEASE left hand button.
Step 2 - Password Change
Note:
1. ROTATE Dispense Controller to enter password code.
The default password is 000.
2. PRESS Dispense Controller once.
3. ROTATE Dispense Controller to enter new password.
4. PRESS TICK
Step 3 - Purification Pack Replacement Date
The replacement date for Purification Packs is automatically
calculated from information held on data tags secured to the
pack. The information displayed confirms the replacement
dates and the serial numbers of the packs that have been
installed.
Note:
1. PRESS TICK
Step 4 - UV Lamp Replacement Date (if fitted)
1. PRESS RESET
Date
PRESS TICK
and proceed to Filter Replacement.
2. PRESS TICK
required
PRESS CROSS
3. PRESS TICK
PURELAB Classic Version 2 11/15
PURELAB Classic Operator Manual
Before resetting any of the Consumable
Replacement/Reminder
that the appropriate new Consumable
has been installed and correctly located
in the PURELAB Classic.
If you do not wish to change password then
proceed to instruction 4.

button to accept new password.
At this stage the unit will not have been fitted
with any Purification Packs and the date
displayed will not
installation of the packs this date will be
changed and reconfirmed.

button.
button to reset UV Replacement
OR

button to accept Replacement Date

button to confirm that resetting is
OR

button to abort reset.

button.
Dates, ensure
be relevant. Upon
Page 21