ELGA PURELAB Classic - US Operator's Manual page 25

PURELAB Classic Operator Manual
Temperature Alarm Setting Screen
Display Viewing Angle Adjustment
Auto-Restart Screen
Reservoir Level Screen
Page 20
Step 9 - Temperature Alarm Setting
The temperature of the water is constantly monitored to ensure
that it does not increase to an unacceptable level. The
PURELAB Classic will alarm and switch the process off if the
alarm point is exceeded.
1. PRESS SCROLL
Note: To operate the unit without a temperature
alarm PRESS SCROLL
highlighted. The unit will switch the process
mode off at 50°C to prevent damage.
2. PRESS TICK
Step 10 - Display Viewing Angle Adjustment
The angle of the display can be electronically adjusted up and
down to optimize the display graphics visibility.
1. ROTATE Dispense Controller slowly to adjust viewing
angle.
2. PRESS TICK
Step 11 - Auto-Restart
This allows the selection of the AUTO/MANUAL restart option. If
auto restart is selected the unit will automatically restart after a
temporary loss of power to the unit. In manual mode the unit will
remain in standby mode.
1. PRESS SCROLL
2. PRESS TICK
Step 12 - Reservoir Level
When operating the system from a reservoir it is recommended
that a low-level switch be connected to protect the system from
running dry.
1. PRESS SCROLL
and level control are attached).
2. PRESS TICK
The Controller Set-up is now complete.
Note: To escape from any of the set-up screens
press the PROCESS button.
PURELAB Classic Version 2 11/15
button to highlight appropriate box.
until no boxes are

button.

button.
button to highlight appropriate box.

button.
button to highlight box, (if reservoir

button.
ELGA