ELGA
Connector
Collet
Depress
collet
Clean square
cut end
Simply push in tube to attach
Tube in secured position
Fitting tubes
Feed Water Inlet
UF Drain
Inlet
Inlet and Drain Connection
5.3
Blanking
transit plug
Once the PURELAB Classic unit has been positioned either on a wall
or on a bench, it should be connected as follows:
Pull plug
Tube 8mm OD
PURELAB Classic Version 2 11/15
Connecting the PURELAB Classic
Mains water inlet tube
UF drain tube - to drain
Step 1 - Remove Transit Plugs
1. PUSH in collet on connector.
2. PULL out transit plug.
3. CUT a clean square end on an 8 mm OD semi-rigid
drain tube.
4. PUSH tube into connector.
Step 2 - Connect Water Inlet
1. Connect 8 mm tube from the PURELAB Classic inlet to
the inlet strainer.
2. Connect the inlet strainer to the pre-purified water
supply.
Step 3 - Connect Drain
1. Connect 8 mm tube from the UF drain (if fitted) and
direct to a suitable drainage point.
CAUTION!
The drain line should allow a gravity
fall to drain with no restrictions.
PURELAB Classic Operator Manual
Page 15