Initial Controller Set Up - ELGA PURELAB Classic - US Operator's Manual

ELGA
Left hand Centre
Control button Control button
Control Panel
Start Up Screen
Password Screen
5.4
Process button
The PURELAB Classic control panel is fitted with four control
buttons. These are:
When the PURELAB Classic unit is started for the first time after
installation the following steps should be carried out to set up system
preferences:
Step 1 - Setting Up Menu Options
Right hand
Control button
Step 2 - Password
PURELAB Classic Version 2 11/15

Initial Controller Set up

1. The PROCESS
purification process ON and OFF.
2. Three software controlled touch pad buttons which are
used to control set-up and process control functions.
1. SWITCH the mains power on to initialize the controller
hardware set-up sequence.
Note: Always allow the initialization process to
complete. Leaving the by-pass block in place
of DI pack, press the PROCESS button to
return to the initial power up screen.
2. PRESS MENU
sequence.
A series of set-up screens will now be displayed.
Various control icons are used to allow you to step
through the set-up instruction process. These icons
include:

A "scroll" icon indicated by an arrow

An "accept" icon indicated by a tick

A "selection" icon indicated by a
At any stage during the Controller Set-up the
PROCESS button can be pressed to escape back to
the initial power up screen.
Restricts access to set up menu sequence.
1. ROTATE Dispense Controller to enter password code.
The default password code is 000.

2. PRESS TICK
Note: To reset password refer to Section 5.5.
PURELAB Classic Operator Manual
button, which switches
button to activate the set up menu


button.
the
Page 17