Muratec F-360 Operating Instructions Manual page 66

4
The shows:
LCD
If you want to overwrite the operation already programmed, press [Yes].
If you want to overwrite only the job's name, press [No] and go to step 8.
If you do not want to overwrite the key you have choice, press
5
Press the keys exactly as you operate the job you want to program into the
Macro key.
Note: It keeps beeping during the job registration in order to make notice of
the registration mode.
Note: You can program up to 60 steps. When it comes over 60 steps, your fax
machine asks if you want to register the operations you have entered.
If you want to register them, press
Note: If you want to cancel the operations you have set, press
, and then go back to step 1.
MACRO PROGRAM STOP
Example 1: To program some operations for copy: Press
copy mode, and set number of the copies, contrast, resolution and reduction
rate as you want.
Note: See "Making copies" (pages 2.10–2.11) for detail operations.
Example 2: To program the operations for printing the one-touch numbers
list: Press , 5, 1, 0, 5,
MENU ENTER
6
If you programmed or
ENTER START
Otherwise, press
MACRO PROGRAM
7
If you want to start immediately after pressing the Macro key when you use
it, press [Yes]. If not, press [No].
Note: If you want to confirm the settings or operations in the Macro key
before you start it, press [No] here.
.
STOP
. If not, press .
ENTER STOP
to change to the
COPY
.
into the operation, proceed to step 7.
and skip to step 8.
8
The now shows:
LCD
The machine now asks you to enter the title of this job.
If you do not want to enter or change it, skip to step 10.
9
Enter the title by using the numeric keypad. (If necessary, review "Entering
characters", page 1.12) It may be up to 130 characters in length.
10
Press to save the setting.
ENTER
Changing the title of the Macro key
When you want to change only the title of a Macro key:
1
Press . The
MACRO PROGRAM LCD
2
Select "Change title" using the cursor key and press
3
Press the Macro key ( 1, 2 or
M M
The shows:
LCD
4
Enter the new title by using the numeric keypad. (If necessary, review
"Entering characters", page 1.12)
5
Press to save the setting.
ENTER
Advanced features
shows:
. The
ENTER LCD
3) you want to change. Then press
M
shows:
.
ENTER
3.19