Sending A Fax Using Monitor/Call Key Or A Handset - Muratec F-360 Operating Instructions Manual

Basic operation
This command number appears on the first line of the
You'll need to know this command number if you later wish to cancel the
transmission or to print a stored document (see pages 2.6–2.7).
5
Now, everything is up to the machines — yours and the one you're dialing.
• If the fax has been set for Quick Memory transmit, your machine scans the
first page of your document into memory, then dials the other fax. When it
makes contact, your machine transmits the stored document from memory
while at the same time scanning the remaining pages of your document
into memory. (In default setting, the Quick Memory transmission is On. If
you want to turn off this feature, see page 4.2.)
• If the fax has been set for the normal memory transmit, your fax scans the
entire document into memory, then dials the other fax. When it makes con-
tact, your machine transmits the entire stored document from memory.
• If the fax is set for Real time transmit (non-memory transmission), your
machine simply dials the other fax. When it makes contact, your machine
feeds the document through, scanning and transmitting it as it goes.
Note: The more "stuff" (called black coverage) your machine "sees" on a
page, the slower the page feeds through as the fax scans it. And even
if the page is relatively clean, sending it in grayscale mode or at cer-
tain resolutions makes your machine "see" more "stuff."
The same is true if you set the contrast to Dark.
Important: If you want to cancel a transmission while scanning the docu-
ment, press the
If you want to cancel a transmission in progress, use the Review
Commands feature. See "Reviewing or canceling commands,"
page 2.6.
6
At the end of the operation, your fax machine beeps and displays:
Important: Whenever you transmit a document, what actually appears on
the top line of the display depends on information stored in the
remote fax. The line may even be blank.
Note: If the call fails, see "Redialing," page 2.5.
2.4
for a few seconds:
LCD
key.
STOP
Sending a fax using
MONITOR
You also can fax a document using either the monitor speaker or the optional
handset to dial the call.
1
Insert the document to the
ADF
2
Obtain a dial tone, either by:
• Pressing /
MONITOR CALL
... or ...
• Lifting the optional handset.
In either case, the shows:
LCD
3
Enter the fax number by using the numeric keypad.
Also, enter access codes with the number, just as for a regular phone call.
4
When you hear fax tones from the remote unit, press
Note: If a person answers the phone, use the optional handset to tell that
person that you're trying to send a fax. When you hear fax tones,
press .
START
5
If you're using an optional handset, hang up after pressing
6
At the end of the operation, your fax machine will beep and display:
Note: If the call fails and you used
/ to hang up. Or if you've pressed
MONITOR CALL
transmission, press
STOP
Also see "Redialing manually," next page, if the call fails.
/ key or a handset
CALL
. If necessary, adjust resolution and contrast.
.
START
.
START
/ to dial, press
MONITOR CALL
to begin the fax
START
to end it.