Radio Receiver; Receiver Technical Specifications; Radio Channel Functionality; Antenna Installation - BFT PERSEO-CBE Installation And User Manual

EN
Description of level 4 parameters
:
·
Setting communication protocol.
Set value always same to Master and Slave.
:
·
Setting U-LINK mode.
:
·
Setting U-LINK adress.

9. RADIO RECEIVER

- Max. n° of transmitters that can be memorized:
- Frequency:
- Code by means of:
- N° of combinations:
Use an antenna tuned to 433MHz. Con-
nect the tuned antenna to the antenna
terminals using RG58 coaxial cable.
In the case of standard installations where no advanced functions are required, it is possible to proceed to manual
storage of the transmitters, making reference to programming table A and to the example for basic programming.
1) If you wish the transmitter to activate output 1, press pushbutton PR1, otherwise if you wish the
transmitter to activate output 2, press pushbutton PR2.
2) When LED DL1 starts blinking, press "hidden key" on the transmitter, LED DL1 will remain continuously lit.
3) Press the key of the transmitter to be memorized, LED DL1 will ash quickly to indicate that it has been
memorized successfully. Flashing as normal will then be resumed.
4) To memorize another transmitter, repeat steps 2) and 3).
5) To exit memorizing mode, wait for the LED to go o completely or press the key of a remote control that
has just been memorized.
IMPORTANT NOTE: ATTACH THE ADHESIVE KEY LABEL TO THE FIRST MEMORISED TRANSMITTER (MASTER).
In the case of manual programming, the rst transmitter assigns the key code to the receiver; this code is necessary
in order to carry out subsequent cloning of the radio transmitters.
This mode is used to copy the keys of a transmitter already stored in the receiver memory, without accessing
the receiver.
The rst transmitter is to be memorised in manual mode (see paragraph 9.4).
a) Press hidden key on the transmitter already memorised.
b) Press key T on the transmitter already memorised, which is also to be attributed to the new transmitter.
c) Within 10 s., press "hidden key" on the new transmitter to be memorised.
d) Press key T to be attributed to the new transmitter.
e) To memorise another transmitter, repeat the procedure from step (c) within a maximum time of 10
seconds, otherwise the receiver exits the programming mode.
f ) To copy another key, repeat from step (a), having waited for the receiver to exit the programming mode
(or after disconnecting the receiver from the power supply).
Control unit

9.1 RECEIVER TECHNICAL SPECIFICATIONS

9.2 RADIO CHANNELS FUNCTIONALITY
Channel 1: Select the command from parameter
Channel 2: Closes the relay contact on the terminal block J4: OUT4, OUT5,
if activated

9.3 ANTENNA INSTALLATION

J5B

9.4 MANUAL PROGRAMMING

9.5 SELF-LEARNING MODE PROGRAMMING

:
·
Setting Modbus/RTU ID.
:
·
Setting MODBUS RTU speed
:
·
Show the list of error codes and the number of time they occur,
alternatively.
2048
433.92MHz
Rolling-code algorithm
4 billion
= - level 2, = - level 2 (default).
- 34 -
- level 2
antenna cable RG58
"Hidden key"
"Hidden key"
T1
T3
T2
T4