Table of Contents
Advertisement
HD9010TM High Definition Time Code Master Manual
AUXCOM BAUD RATE
Aux com =xx
3.7.5. Working with System Parameters
The HD9010TM allows the user to control various seldom-used features and debug aids by the use of
system parameters.
parameters are identified by a parameter number. Each parameter has a 4 byte signed binary number
value with the default value for each parameter being zero. There are two menus item used to set the
System parameter class and number and a third menu item, to change its value. Contact the factory
before changing any System parameters from their default values.
SYS PARM CLASS
Sys prm class=0
SYS PARM NUMBER
Sys prm num=0
SYS PARM VALUE
Sys prm value=0
3.7.6. Viewing the Hardware Version
HARDWARE VERSION
Rev 1 (7700PB3)
Rev 2 (7700PH4)
3.7.7. Viewing the Firmware Version
FIRMWARE VERSION
TM 2.0 build 138
Page 3-24
The AUXCOM BAUD RATE menu item is used to set the baud rate of
the AUX COM serial port. (On earlier versions of the HD9010TM this
serial port was labelled COM 2.) Turn the shaft encoder to adjust. This
serial port is not used at this time.
These parameters are grouped according to classes.
This menu sets the system parameter class for the parameter value you
want to change.
This menu sets the system parameter number for the parameter value
you want to change.
This menu changes the value of the system parameter selected by the
SYS PARM VALUE and SYS PARM NUMBER menu items.
The Hardware Version menu item allows you to identify the revision of
the main board that is installed in the HD9010TM. When you press the
SELECT key, the display shows the hardware version which will be
something like:
Rev 2(7700PH4)
The Firmware Version menu item allows you to view the firmware
version that is installed in the HD9010TM.
SELECT key, the display shows the software version which will be
something like:
Tm 2.0 build 138
Revision 2.4.1
Within each class,
When you press the
OPERATION
Advertisement
Table of Contents
