Table of Contents
Advertisement
HD9010TM High Definition Time Code Master Manual
Turn the SHAFT ENCODER knob to change the value of the displayed parameter. When the value
shown is not the active value the display will stop blinking. When you have selected the desired
parameter value press the SELECT key to make that value the active value. (The display will start
blinking again). Press the ESC key when the display is blinking to move back up the menu to the top
saving your selection. You can press the ESC key when the display is not blinking to move back up the
menu to the top level without saving your selection. You can select other menu items from the top level
by turning the SHAFT ENCODER knob, followed by the SELECT key. Alternately you can exit the
setup menu and return to the normal DISPLAY mode by pressing the ESC key.
Figure 3-2 gives an overview of the setup menu. Sections 3.4 to 3.7 provide detailed descriptions of the
GENERATOR, READER, VCG and UTILITY SETUP menus.
arranged in an indented structure to indicate the path taken to reach the control.
3.4.
CONFIGURING THE GENERATOR
The GENERATOR SETUP menu is used to set up various generator modes such as selecting Drop
Frame, Jam Sync Modes, ATC Generator Line number, whether user bits contain static numbers or
time information, etc. The chart below shows the items available in the GENERATOR SETUP menu.
Sections 3.4.1 to 3.4.9 give detailed information about each of the sub-menus.
GEN MODE
GEN ATC TYPE
GEN DROP FRAME
GEN LTC PARITY
GEN NO CODE JAM
Page 3-8
Sets the operating mode of the LTC and ATC generators
Selects whether LTC or VITC or both ATC packets will be inserted
Configures the generator drop frame mode
Configures the parity of the LTC generator
Configures the action when input code is missing and the HD9010TM is
in continuous JAM sync mode
Table 3-1: Top Level of the Generator Setup Menu
The tables in these sections are
Revision 2.4.1
OPERATION
Advertisement
Table of Contents
