Selecting The Generator Framing Reference; Adjusting The Output Level Of The Ltc Generators; Adjusting The Baud Rate Of The Serial Ports - evertz HD9010TM Instruction Manual

3.7.2. Selecting the Generator Framing Reference

REFERENCE MODE
Ref: input
Ref: tri-lvl
Ref: bi-lvl

Regardless of the setting of this menu control the HD9010TM requires a stable
video input for normal operation.

3.7.3. Adjusting the Output Level of the LTC Generators

LTC LEVEL
Ltc level =xx
AUX LTC LEVEL
Aux ltc level =xx

3.7.4. Adjusting the Baud Rate of the Serial Ports

COM 1 BAUD RATE
Com 1 =xx
OPERATION
HD9010TM High Definition Time Code Master Manual
The REFERENCE MODE menu item is used to set whether the
internal timing of the HD9010TM will be locked to the input video or the
External Reference input.
character displays and LTC phasing, and output video timing reference
signals (TRS) are in turn locked to the internal timing reference of the
HD9010TM.
Select input to reference the HD9010TM to the input video. This setting
will cause the internal timing reference of the HD9010TM to become
disrupted and unlocked when an HD input signal is not present. This
may cause disturbances in the output video, but is the preferred method
when you cannot time the input video to the reference within one line.
Select tri-lvl to reference the HD9010TM to a tri-level sync signal
applied to the GENLOCK input.
HD9010TM to a bi-level sync signal applied to the GENLOCK input.
These settings will allow the internal timing reference of the HD9010TM
to remain locked to the reference when an HD input signal is not
present, providing a stable video output. The input video must be timed
to the sync reference within one horizontal line period for proper
alignment of the picture content on the output video. The format of the
reference sync signal must be in accordance with the standards shown
in Table 2-5.
The LTC LEVEL menu item is used to adjust amplitude of the main
LTC output. Turn the shaft encoder to adjust. The recommended
output level setting is 35, which is approximately 1 volt peak to peak.
The AUX LTC LEVEL menu item is used to adjust amplitude of the
auxiliary LTC output.
recommended output level setting is 35, which is approximately 1 volt
peak to peak.
The COM 1 BAUD RATE menu item is used to set the baud rate of the
COM 1 serial port. Turn the shaft encoder to adjust. This serial port is
used to broadcast time and user bit data in a packed BCD format.
Contact the factory for further information. Note that the setting of this
menu item does not affect the firmware upgrade baud rate. See section
4.2.2.
Revision 2.4.1
The updating of the generator clock,
Select bi-lvl to reference the
Turn the shaft encoder to adjust. The
Page 3-23