Table of Contents
Advertisement
HD9010TM High Definition Time Code Master Manual
SELECT When in one of the Setup menus the SELECT key is used to move to the next lower sub-
menu levels or to select a menu parameter that is to be changed. The SELECT key is also
used in combination with the numeric keys to enter numeric data.
ESC
When in one of the Setup menus the ESC key is used to move to the next lower sub-menu
levels or to select a menu parameter that is to be changed. The ESC key is also used to
cancel the process of entering numeric data.
SHAFT ENCODER
When in one of the Setup menus, the SHAFT ENCODER knob is used to move
to various items in the menu system. (See also section 3.3)
3.1.2. The Display Button Group
The Display pushbutton group consists of the DISPLAY key and is used to select the information being
displayed on the front panel when you are not in one of the Setup menus. After you press the DISPLAY
key, you can use the SHAFT ENCODER knob to select the Status or Display items.
DISPLAY Allows you to quickly view the various times of the readers and generators, as well as other
display data. (See section 3.2.1)
3.1.3. Panel Lock Key Functions
PANEL LOCK
Pressing this key while holding down the SHIFT key will lock the front panel. The
LED beside the PANEL LOCK key will come on indicating that the front panel keys are
disabled. Pressing the PANEL LOCK key while holding down the SHIFT key again will
return the front panel keys to their normal functions and the PANEL LOCK LED will go Off.
When the PANEL LOCK GPI has been activated, you cannot unlock the front panel
using the SHIFT+PANEL LOCK keys.
LOCKED BY REMOTE.
3.1.4. The Character Window Pushbutton Group
SELECT Initiates VCG Window Select Mode and highlights the Generator time VCG window. Hold
the HORZ or VERT keys down while turning the SHAFT ENCODER to move the window,
use the CHAR GEN ON/OFF key to turn the window on or off.
ENCODER without holding any keys down to select the next window and so on. Press The
SELECT key to return to the normal VCG display mode.
ON/OFF
Turns the character generator ON and OFF. When in the VCG Window Select Mode the
CHAR GEN ON/OFF key is used to turn individual windows ON and OFF.
HORZ
When in the VCG Window Select Mode, press this key and turn the SHAFT ENCODER
knob to position the highlighted character window horizontally on the screen. (See also
section 3.6.3.)
When not in the VCG Window Select Mode, press this key and turn the SHAFT ENCODER
knob to position all the character windows horizontally on the screen. (See also section
3.6.4.)
VERT
When in the VCG Window Select Mode, press this key and turn the SHAFT ENCODER
knob to position the highlighted character window vertically on the screen. (See also section
3.6.3.)
Page 3-2
The front panel display will show
Revision 2.4.1
Rotate the SHAFT
OPERATION
Advertisement
Table of Contents
