Advertisement
Available languages
Available languages
PROBLEM
Water doesn't come
through (the machine
makes a loud noise).
Machine is on but
ceases to operate.
2-cup coffee
button flashing
Too much/too little
espresso is being
delivered to the cup.
22
POSSIBLE CAUSES
• Water tank is empty or water level
is below minimum.
• Water filter has been inserted
without soaking.
• The safety thermal-cut out may
have activated due to the pump
overheating.
• This indicates machine needs
cleaning and descaling
• Grind amount and/or grind size
settings and/or shot volumes
require adjustment.
EASY SOLUTION
• Fill tank
• Ensure the water filter has been
soaked for 5 minutes before insterting
into the water tank.
• Press the 1 CUP and HOT WATER
buttons simultaneously for
0.5 seconds to switch the machine
off and unplug from the power
outlet. Allow to cool for about
30–60 minutes. If problem persists,
call Sage Support.
• Perform a clean and descale cycle.
Follow the steps outlined on
page 17.
• Adjust the grind amount and/or grind
size settings. Refer to 'Coffee Dose
and Tamping', page 13, 'The Grind',
page 13 and 'Extraction Tips',
page 16.
Advertisement
