Advertisement
Available languages
Available languages
EXTRACTING ESPRESSO
As a guide the espresso will start to flow after
8–12 seconds (infusion time) and should be
the consistency of dripping honey.
If the espresso starts to flow after less than
7 seconds, you have either under dosed the
filter basket and /or the grind is too coarse.
This is an UNDER EXTRACTED shot.
If the espresso starts to drip but doesn't flow
after 12 seconds, the grind is too fine. This is
an OVER EXTRACTED shot.
PRE-PROGRAMMED SHOT VOLUME
- 1 CUP
Press the 1 Cup button for less than 1 second,
the button will flash indicating that it has been
selected. A preset single espresso volume
of approximately 30ml will be extracted.
The machine will automatically stop once
the pre-set volume has been extracted.
PRE-PROGRAMMED SHOT VOLUME
- 2 CUP
Press the 2 Cup button for less than a second,
the button will flash indicating that it has been
selected. A preset double espresso volume
of approximately 60ml will be extracted. The
machine will automatically stop once the
pre-set volume has been extracted.
14
NOTE
Pressing the corresponding 1 Cup or 2 Cup
button during the programmed espresso
extraction will immediately stop the
extraction.
PROGRAMMING COFFEE VOLUME
Press and hold the 1 Cup and 2 Cup buttons
for 2 seconds, the buttons will illuminate
and flash.
+
To set the 1 Cup volume:
• Press the 1 Cup button for about 3 seconds
to start the extraction.
• Press the 1 Cup button again to stop the
extraction. The modified volume will be
saved.
To set the 2 Cup volume, follow the above
steps and select the 2 Cup button to start
and stop the extraction.
NOTES
• If no user input after 30 seconds.
Machine returns to 'ready mode'
• The modified coffee volume will be saved
into memory for the next use or when
the machine is re-started.
• Pressing the steam or hot water button at
any stage will cancel the operation and the
machine will return to ready mode without
saving any coffee volume program.
MANUAL PRE-INFUSION AND SHOT
VOLUME
Press and hold the 1 Cup or 2 Cup button
for more than a second. After one second
the pump will start at pre-infusion pressure
and continue while button is pressed.
Release the button to start the extraction.
Press any button again to stop the extraction.
2 s
Advertisement
