Human Machine Interface - Removal - Maytag Commercial MYR20 Service Manual

HuMan MaCHine inTerFaCe - reMOvaL

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. To remove the Human machine interface,
open the control panel (See page 4-18).
2. Press the locking tab and disconnect the
wire harness connections to the HMI
(See page 4-21).
3. Remove four #1 Phillips head screws
securing the HMI to the control panel.
Four Phillips
Screws
TeCH Tip: Before touching electronic
parts, touch bare metal on the washer to
ground any static that has built up.
4. Lift the HMI off the control panel. The
display is on the back side of the HMI.
4-22