Supply Power Switch - Maytag Commercial MYR20 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. The supply power switch is operated from
the back of the washer. Turn the switch a
quarter turn clockwise to turn the washer
on, and a quarter turn counter clockwise to
turn the washer off.
2. To remove the switch, loosen the number
two Phillips screws securing the incoming
power wires to the top of the switch, inside
the washer cabinet. Remove the wires
3. Loosen screw securing ground wire, with a
flat blade screwdriver. Remove the wire
Ground
Wire

SuppLY pOWer SWiTCH

Power
Wires
4-10
4. To remove the knob, use a number one
Phillips head screwdriver to remove the
screw in the center of the knob.
5. Pull the knob off.
6. Remove two number one Phillips screws
that were hidden by the knob, securing the
switch face to the back of the washer.
7. Remove the switch face.
8. Remove four number two Phillips screws
hidden by the switch face, securing back
plate to the switch inside washer cabinet.
When removing the last screw, support the
switch body inside the washer cabinet.
9. Pull the switch body out of the hole in the
back panel.
10. Remove the switch back plate from the
back panel.
11. There is a rubber insulator gasket, behind
the back plate, attached to the back panel
that does not need to be removed.
Two Phillips
Screws