Door And Door Hinges - Maytag Commercial MYR20 Service Manual

1. To remove the door hinges, open the
washer door.
2. Remove three T-30 screws from the top
hinge block attached to the door.
3. Support the door when removing the last
screw.
4. Move the top hinge block away from the
door.
5. Lift the door off the bottom hinge pin and
remove the door.
6. Remove top hinge block from the hinge pin.

DOOr anD DOOr HinGeS

Three T-30
Screws
4-28
7. There is a shim on each hinge block
positioned between hinge block and door.
8. To remove the hinges, remove two T-30
screws from each hinge.
Two T-30
Screws
9. Support the hinges when removing the last
screw.
10. There are no shims behind the hinges.
11. Remove the bottom hinge the same way.
nOTe: The longer screws are used for
the hinges on the washer front panel. The
shorter screws are used for the hinge blocks
on the door.