Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Connections on the HMI are:
J5 - Communication cable to the ACU board,
J3 - Wifi connector,
J10 and J11 - USB connectors,
Ribbon cable - membrane keypad,
J5
HMi - COnneCTiOnS
J8 - Coin 1 and coin 2 connector,
J7 - Service and vault switch connector,
J6 - Gen 2 card reader connector.
There is a 3 volt battery on the HMI, to
maintain real time clock, in case of power loss.
J3
J10
J11
4-21
J8
J7
3 Volt
Battery
Keypad
Ribbon Cable
J6