Water Inlet Valve Removal - Maytag Commercial MYR20 Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. To remove a water inlet valve, disconnect
all the wire connectors from the valves.
2. Remove two Phillips head screws securing
the water inlet valve to the back panel of the
washer.
Two Phillips
Screws
3. Pull the water inlet valve assembly out of
the hole in the back panel from inside the
washer.

WaTer inLeT vaLve reMOvaL

4. Use a 7mm nut driver, Phillips, or Flat blade
screwdriver to loosen hose clamps securing
the water inlet hoses to the valve assembly.
5. Slide the hose clamps down the hoses.
6. Use a twisting motion while pulling to
remove the hoses from the valves.
7. Make sure to mark the hoses and valves for
proper reinstallation.
4-16