Door Handle; Door Strike - Maytag Commercial MYR20 Service Manual

DOOr HanDLe

1. To remove door handle, open washer door.
2. Remove four T-30 screws securing the
door handle to the door. These are machine
screws with permanent washers
3. Support handle when removing last screw.
4. Remove the handle from the slots in the
front of the door.
1. To remove door strike, open washer door.
2. Remove two #5 hex screws securing the
door strike to the inside of the door.
Four T-30
Screws
3. Remove the spring behind the strike. The
spring allows the strike to move a little for
proper operation of the strike.
4. Before tightening the door strike screws
completely, test closing the door to make
sure strike is aligned correctly for the hole.
5. When alignment of the strike is correct,
tighten the two mounting screws.
6. Test closing the door when the reinstallation
is complete.
4-27

DOOr STriKe

Two #5 Hex
Screws